Selfholding solenoid GMH-26.06

Selfholding solenoids
Dimensions: 30 x 26 x 63

Simple selfholding solenoid in open design with a currentless held end position thanks to built-in permanent magnet.

Specifications

Electrical power
Force
55W
Pulling force
20N
Permanent holding force
(currentless)
35N
Electrical power
Neutralize
3.78W
Nominal voltage
24 VDC
Duty cycle ED%
(cycle time 30s)
10%
Insulation class
B (130°C) DIN VDE 0580
Test voltage
Overvoltage category
EN 60664-1
III
Protection class
IP00 (IEC 60529)
El. connection type
Socket tongues 2.8 x 0.8 DIN 46342-1
Surface treatment
Housing zinc plated & blue passivated, armature chem. nickel plated
Anchor weight
0.046 kg
Total magnet weight
0.245 kg

Technische Daten

Notes

  1. Magnets manufactured and tested according to DIN VDE 0580
  2. Magnetic force measured at operating temperature at 20°C ambient temperature, horizontal direction of movement with 90% nominal voltage
  3. Attracting the magnet positive pole of the net to positive pole of the coil (+)
  4. Neutralise by means of electrical impulse positive pole of the mains to negative pole of the coil (-)
    Attention: Reduced power
  5. The magnetic holding force values are only valid as reference values and may deviate by ±10% due to tolerances
  6. Residual magnetism approx. 10% of the permanent holding force
  7. Special versions are available
  8. Subject to change without notice - Illustrations non-binding
  9. RoHS conform
  10. Our "Technical Explanations" provide information on the use of holding magnets as well as to general assembly and safety instructions

Got questions?

Leave us your question, we will answer it as soon as possible.